K-Array Mugello-KH3

Thương hiệu: K-Array – Ý
Sản xuất: Ý
Loa active line array
Ampli class D / 2 x 1600W @ 4Ω
Tần số: 120Hz – 19kHz
Max SPL: 138dB
HxWxD: 45.6 x 121.8 x 21cm – 43.6kg
Bảo hành: 12 tháng

(Đối với sản phẩm giá trị cao)

Thông số kỹ thuật

General
Type	Line array element
Transducers	2x 12” neodymium magnet woofer with 2.5” voice coil 2x compression driver with 2.5” voice coil
Frequency Response	120 Hz – 19 kHz (-6 dB)
Maximum SPL	138 dB (peak)
Coverage	110° horizontal; 20° vertical (preset dependent)
Internal Processing
Input Sample Rate and Resolution	Up to 96 kHz @ 24 bit with internal SRC and jitter correction
Built-in DSP	Input gain, delay up to 330 ms 8 full parametric IIR filters (Peaking, Shelving, Hi/Lo pass, Hi/Lo Butterworth) FIR filter for electronic beam steering Onboard presets Level and temperature remote monitoring
Internal amplifier module
Type	2 ch., switch-mode class D
Peak Output Power	2x 1600 W @ 4 Ω 1% THD+N
Operating Range	100-240V AC, 50-60 Hz with PFC
Power Consumption	300 W @ 8 Ω load, Pink noise 1/8 rated power
Protections	Over Temp. (Power Limiting – Thermal Shutdown), Short Circuit/Overload Output Protection, Power Limiting, Clip Limiter/Permanent Signal Limiter, High Frequency Protection
Mains Connector	powerCON with link inlet
Controls and Connectivity
Controls	Remote control with dedicated PC software via USB or RS485 Onboard touch screen display
Connectivity	Analog: 2x XLR (bal) input signal 2x XLR (bal) parallel output Digital: 1x XLR AES3 input 1x XLR AES3 output	Remote connectivity: 1x XLR RS485 serial input 1x XLR RS485 serial output 1x USB-B inlet MAINS: 1x powerCON 1x powerCON link
Handling and Finish
Dimensions (WxHxD)	1218 x 456 x 210 mm (47.9 x 17.9 x 8.3 in) with rigging hardware 1104 x 370 x 200 mm (43.5 x 14.5 x 7.9 in) net dimensions
Weight	43.6 kg / 96.12 lbs (with rigging hardware)
IP rating	20 (53 with K-AMPCOVER accessory)